Gembird EG-PM2-LAN Bedienungsanleitung PDF herunterladen (Seite 28)

EG-PM2-LAN PROGRAMMABLE POWER

OUTLET STRIP WITH LAN INTERFACE

All brands and logos are registered trademarks of their respective owners

On the LAN settings page (see Figure #10 above) you can set up

DHCP, IP address, Subnet mask, Gateway, DNS server and IP filter (up

to 3 IP addresses can then be enabled for remote access).

The new settings will be applied immediately after you press the

Apply button.

IP address, Subnet mask, Gateway, DNS server will be used only if

the DHCP option is disabled.

If you set DHCP option it is recommended for your own convenience

to set up your DHCP server so that it always provides the same IP

address to EG-PM2-LAN. To do that you will need to know the MAC

address of EG-PM2-LAN. It can be found on this page or on the bottom

sticker of the device. The MAC address is fixed and cannot be changed.

DNS server address is important to be properly set up in case you

wish to enable the NTP timer correction option (see section 4.6 below).

IP filter option is needed to prevent unauthorized access to the

server. It restricts the web server access from any computer with IP

address different from IP1, IP2 and IP3. Make sure that you input IP1,

IP2, and IP3 correctly before enabling this option.

Power Manager client port is used for connecting with the Power

Manager software, normally it is not needed to change this setting.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 64 65

Keine Kommentare

Gembird EG-PM2-LAN Bedienungsanleitung Seite 28